Jesada Catalog

List All Products

Advanced Search

Forgot your password?
Forgot your username?
No account yet? Register

VirtueMart Shopping Cart

Your Cart is currently empty.

Attention: open in a new window. PDFPrintE-mail

Three-In-One Bit Instructions

Warning!  Router Table Use Only! Please Note: Wherever you see these pictures, the specified bits are for use in a router table only! Never attempt to use them in a hand-held router!

Cut Profile This bit looks a little like one of our Vertical Raised Panel Bits, but you get lots of work out of the Three-in-one bit without ever making a door panel. Use it to cut chamfers that are as much as 1-5/8" tall. Use it to decorate drawer fronts or produce beveled molding. And of course, you can use it to make perfect raised panels. The bit includes three bearings (1/2", 5/8" and 3/4" diameter). By switching bearings, you can produce a variety of different insets or flush chamfers.

Shop Tips!

  • The Three-in-one bit cuts a bevel that can be used as a comfortable, attractive table edge.
  • If you plan to bevel a door panel or drawer front be sure to rout across the end grain first.
Safety Tips:
  • Use a fence that is at least 6" high when routing raised panels or other wide stock.
  • Use hold-ins when routing stock on-edge.

Possible Bearing Configurations
Illustration Illustration Illustration
1/2" Bearing 5/8" Bearing 3/4" Bearing

Copyright © 1997, Jesada Tools™.
Any reproduction in whole or in part strictly prohibited.